您好!欢迎来访东营博诚长臂挖掘机出租公司!关于我们 | 联系我们 | 在线留言
全国统一服务热线
13793968666(来经理)
联系我们
联系人:王经理
联系电话:13793968666
地址:山东省东营市广饶县
新闻中心

提高挖掘机挖斗需要提前做哪些准备?

日期:2020-04-28   来源:http://www.dybocheng.com
做好施工前的准备
Make preparations before construction
正确的施工组织设计。与挖掘机配合的自卸车数量及承载能力应满足挖掘机生产能力的要求,且自卸车的容量应为挖掘机挖斗容量的整数倍。同时尽量采用双放装车法,使挖掘机装满一辆,紧接着又装下一辆,由于两辆自卸车分别停放在挖掘机挖斗卸土所能及的圆弧线上,这样挖斗顺转装满且车,反转又可装满另一车,从而提高装车效率。
Correct construction organization design. The number and bearing capacity of dump trucks matched with excavator shall meet the requirements of excavator production capacity, and the capacity of dump trucks shall be an integral multiple of excavator bucket capacity. At the same time, try to use the double loading method to make the excavator full of one, and then load the next. Because the two dump trucks are respectively parked on the arc line that the excavator bucket can reach for unloading soil, so the bucket can turn forward to fill the car, and reverse to fill another car, so as to improve the loading efficiency.
拟定正确的自卸车行驶路线。在施工组织中,应事先拟定好自卸车的行驶路线,清除不必要的上坡道。对于挖掘机的各掘进道,须要做到各有一条空车回程道,以免自卸车进出时相互干扰,各运行道应保持良好善,以利自卸车运行。
Draw up the correct route of dump truck. In the construction organization, the driving route of dump truck shall be prepared in advance, and unnecessary ramps shall be removed. For each excavation road of the excavator, it is necessary to have an empty return road to avoid mutual interference when the dump truck enters and exits. Each operation road shall be kept in good condition to facilitate the operation of the dump truck.
掌握节能操作方法
Master the operation method of energy saving
在率区挖掘。率区是指小臂从垂直状态向前面移动45度到向前移动30度之间的范围,在该范围内挖掘,以装满挖斗为宜。(该范围根据机械不同而有所不同)
Excavate in high efficiency area. The high efficiency area refers to the range between 45 degrees to 30 degrees from the vertical to the front of the jib. It is better to excavate in this range to fill the bucket. (the range varies according to the machinery)
不进行多余的挖掘。挖掘机挖斗盛满后继续挖掘将造成燃料浪费,如同引起液压释放等负荷过重情况,只会无畏地消耗燃料,因此请避免。
加长臂挖掘机
No extra excavation. Continue to excavate after the bucket of excavator is full, which will cause fuel waste, just like causing overload such as hydraulic release, which will only consume fuel fearlessly, so please avoid.
在挖掘力较大的位置进行操作。在工作机和气缸角度成90度时挖掘力较大,挖掘力主要利用挖斗的挖出力。
Operate at the place with large excavation force. When the angle between the working machine and the cylinder is 90 degrees, the digging force is large, and the digging force mainly uses the digging force of the bucket.
适时做好维护保养
Timely maintenance
挖斗加固。挖掘机挖斗在使用时,锯齿作为机械末端的装置,特别容易受损,如果条件允许的话,建议使用挖掘机前可以先对挖斗进行加固,这样才能够保障挖斗更加经久耐用,有效的提高工作效率,降低作业成本。
Bucket reinforcement. When the excavator bucket is used, the saw tooth is the device at the end of the machine, which is particularly vulnerable to damage. If conditions permit, it is recommended to reinforce the bucket before using the excavator, so as to ensure that the bucket is more durable, effectively improve work efficiency and reduce operation cost.
避免挖斗尾部刮擦。挖掘机挖斗作业前,应将作业环境进行清理,把旋转半径内高出履带板的所有障碍物扫平。正常情况下,挖掘机挖斗尾部出现刮擦多是旋转的时候造成的,所以操作人员要对尾部旋转半径数据有所了解,这样,在作业的时候,留出合适的距离,才能避免在旋转的时候出现刮擦。
Avoid scraping at the end of the bucket. Before digging, the working environment shall be cleaned and all obstacles higher than the track shoes within the rotating radius shall be cleared. Under normal circumstances, the scraping at the tail of the excavator bucket is mostly caused by rotation, so the operator should understand the data of the tail rotation radius, so that, during operation, a proper distance can be set aside to avoid scraping during rotation.

  • 13793968666
  • 返回顶部

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】