您好!欢迎来访东营市兴达土方工程有限公司!关于我们 | 联系我们 | 在线留言
服务热线
18678687777(来经理)
联系我们
联系人:来经理
联系电话:13793968666
地址:山东省东营市广饶县
租赁动态

加长臂挖掘机租赁介绍挖掘机冒黑烟请注意这5点!

日期:2020-12-30   来源:http://www.dybocheng.com
在长臂挖掘机的高温维护过程中,您是否遇到过柴油发动机产生的黑烟?下面就由小编来为大家来介绍一下:
During the high temperature maintenance of long arm excavator, have you ever encountered the black smoke from diesel engine? Now let's introduce it to you
(1)压缩力不足:气门、活塞环和气缸套磨损,造成压缩压力不足,压缩压力和温度低于标准,燃料燃烧条件恶化,容易产生烟尘;
(1) Insufficient compression force: valve, piston ring and cylinder liner wear, resulting in insufficient compression pressure, compression pressure and temperature lower than the standard, fuel combustion conditions deteriorated, easy to produce smoke and dust;

(2)燃烧室形状和体积的变化:由于制造质量和长期使用,燃烧室的技术条件降低,压缩间隙的变化也会改变燃烧室的形状和体积,从而影响燃料和空气的混合质量,并使燃烧条件恶化。如果活塞反向安装,会影响喷油器、燃烧室和进气道的匹配工作,不会形成良好的混合气,会发生不完全燃烧。
(2) Change of combustion chamber shape and volume: due to the manufacturing quality and long-term use, the technical conditions of combustion chamber are reduced, and the change of compression gap will also change the shape and volume of combustion chamber, thus affecting the mixing quality of fuel and air, and making the combustion conditions worse. If the piston is installed in the opposite direction, the matching work of the injector, combustion chamber and intake port will be affected, the good mixture will not be formed, and incomplete combustion will occur.
加长臂挖掘机出租
Extended boom excavator rental
(3)喷油器工作不良:喷油器工作不良主要表现在三个方面:一是喷油器质量差;第2,喷油器压力不足。第三,注射器滴水。在这三种情况下,燃料不能与气缸中的空气完全混合,因此不能完全燃烧。此外,如果选定的喷油器与原发动机不匹配,也会导致发动机冒烟。
(3) Poor working of fuel injector: the poor working of fuel injector is mainly manifested in three aspects: first, poor quality of fuel injector; second, insufficient pressure of fuel injector. Third, the syringe drips. In these three cases, the fuel cannot be completely mixed with the air in the cylinder, so it cannot be completely burned. In addition, if the selected injector does not match the original engine, it will also cause the engine to smoke.
(4)供油过多,供油过多,导致混合气浓度高,燃烧不完全;
(4) Too much fuel supply leads to high mixture concentration and incomplete combustion;
(5)提前角不当:①供油提前角过大:在直喷式柴油机中,当其他参数不变时,适当增加喷油正时可以减少排气烟度。随着燃料喷射时间的增加和点火延迟时间的延长,在所有喷射燃料的火焰上升之前进行预混,以增加预混气体的量,加速燃烧速度,并且燃烧可以提前完成,因此快速燃烧形成的碳颗粒将在高温下停留更长的时间,这有利于烟灰的氧化和消失。
(5) Improper advance angle: ① the fuel supply advance angle is too large: in the direct injection diesel engine, when other parameters remain unchanged, appropriately increasing the injection timing can reduce the exhaust smoke. With the increase of fuel injection time and ignition delay time, premixed fuel is used to increase the amount of premixed gas and accelerate the combustion speed before the flame of all injected fuel rises, and the combustion can be completed ahead of time. Therefore, the carbon particles formed by rapid combustion will stay longer at high temperature, which is conducive to the oxidation and disappearance of soot.
然而,由于缸内压力和温度较低,过早喷射不利于燃料蒸发和混合,导致烟雾排放。同时,由于预混合燃料的量大大增加了粗柴油的量,燃烧噪音增加并导致更大的机械负荷。(2)供油提前角过小:当燃油喷射到后期时,在气缸内形成燃油的燃烧部分已为时过晚,混合气在气缸内被分离或排出,从而产生一些物质和燃气,与排气管内的废气一起通过热解和燃烧排出。
However, due to the low pressure and temperature in the cylinder, premature injection is not conducive to fuel evaporation and mixing, resulting in smoke emission. At the same time, because the amount of premixed fuel greatly increases the amount of crude diesel, the combustion noise increases and leads to greater mechanical load. (2) The fuel supply advance angle is too small: when the fuel is injected to the later stage, it is too late to form the combustion part of the fuel in the cylinder, and the mixture is separated or discharged in the cylinder, thus producing some substances and gas, which are discharged together with the exhaust gas in the exhaust pipe through pyrolysis and combustion.


【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】